Thanks for taking the time to check out this 1 owner 2021 Kenworth T270 mechanics truck. Powered by a Paccar PX9 350hp engined, mated to an Allison automatic transmission. Air ride and locking rear, 26000 GVWR, under cdl. Showing 103,435 miles and 3,602 hours at the time of this writing.

Equipped with an 11′ Summit service body, a Summit 10620 crane and factory wireless remote, one set of Summit drawers, hydraulic outriggers, hydraulic Vanair RC40 compressor, one waste and one fresh oil tank (40g), and a Miller Bobcat 250 welder.

Fully serviced, needs nothing, turnkey truck ready to go to work. Repairs just completed include:

Oil change and new fuel filters, new DPF pressure sensor, new rear shocks, new batteries, new rear brake shoes and drums, and new crane wear pads.

All of the doors on the bed close, latch, lock, and seal as they should. We have the bin keys and all of the latches are keyed the same. Interior compartment lighting throughout, all operational. Exterior work lighting on both bedsides and the rear of the bed, all operational.

The D1 compartment houses the truck batteries and master disconnect switch, and has three shelves. The D2 compartment has a full set of Summit drawers, eight total, and one shelf. One shelf over the driver wheel well compartment. Two shelves in the driver rear compartment.

Work bench rear bumper with pass through bin storage, hydraulic outriggers, and a tow hitch receiver.

The crane compartment has two Summit drawers, the body control panel which can start/stop the truck, turn the PTO on, idle the truck up, control all bed lighting, as well as run the crane. A Hannay hose reel and air regulator/drier, and the factory wireless remote.

One shelf over the passenger wheel well compartment. Two shelves in the P2 compartment. Three shelves in the P1 compartment as well as bottle racks.

The crane is a Summit 10620 with a 10,000# maximum lifting capacity and a two stage hydraulic extension out to 20′. Run off a factory wireless remote, the remote can turn the truck on and off as well as control the compressor.

The compressor is a Vanair RC40 hydraulic unit, showing 29 hours. Builds air quickly and runs as it should.

Two product tanks in the bed, one waste and one fresh, both 40g capacity and run off air pumps. Miller Bobcat 250 welder with leads.

The cab interior is clean and free of any rips or tears. Power locks, power windows, cruise control, and factory exhaust brake.

If you have any questions or if you need any additional photos, videos, or information – please call or text 804-716-8487 anytime.

Offered for sale by Truck World RVA in Oilville VA.