Thanks for taking the time to check out this 1 owner 2015 Ram 5500 Cummins service truck, coming to us out of South Carolina, with no reported accidents on the CARFAX history report. Powered by a 6.7 Cummins diesel mated to an Aisin automatic, this truck is 2WD and shows 219,367 miles and 8,500 engine hours at the time of this writing.

Well equipped with an 11′ Summit service body, hydraulic outriggers, a Vanair RC40 hydraulic compressor, 6620 hydraulic crane, Lincoln 305G welder, and one set of drawers. All of the equipment works as it should.

Fully serviced and ready to go to work. Repairs just completed include:

Oil change and new fuel filters, all oil leaks repaired (new rear main seal, timing cover gasket, and oil pan gasket), new AC compressor, new rear springs, new rear pads and rotors, new tires (all 6), new driver front wheel bearing, a new PTO pump, and a new starter.

We use all OEM parts when reconditioning our trucks. Anything we find that needs attention, we address. I can send receipts for all work just performed.

The bed is an 11′ Summit service body, with factory paint intact. It has some minor rock chipping, but overall is solid and free of any rust. All of the doors close, latch, lock, and seal as they should. We have the bin keys and all of the latches are keyed the same.

The D1 compartment has a full set of Summit twist lock drawers, seven total. Three shelves in the D2 compartment. One shelf over the driver wheel well compartment. Two shelves in the driver rear compartment.

Work bench rear bumper with pass through bin storage, hydraulic outriggers, a tow hitch receiver, and rear LED work lights.

The crane compartment houses a body control panel (to control all bed lighting, and hydraulics), has one shelf, a Hannay hose reel with air regulator/drier, and a factory wireless remote.

No shelving over the passenger wheel well compartment. Two shelves in the P2 compartment. The P1 compartment has three shelves on the left side, and is taller to fit torch bottles, with torch bottle racks on the right side.

The crane is a Summit 6620 series crane, with a 6,000# maximum lifting capacity and a two stage hydraulic extension out to 20′ of total reach. The remote can control the compressor, and can also turn the truck on and off.

The compressor is a Vanair RC40 unit, builds air quickly and runs as it should, showing 79 total hours.

The welder is a Lincoln 305G vantage, comes with a new set of leads, and also shows 79 total hours.

The interior is clean and free of any rips or tears. Factory exhaust brake, power locks, power windows, and cruise control.

If you have any questions or if you need any additional photos or videos, feel free to call or text anytime. All trucks are offered on a first come, first serve basis. Please call ahead to confirm availability.