• Mon, Thurs, Fri 11AM-5PM, Sat 11AM-3PM

2013 Freightliner M2, 4×4, Cummins ISC Diesel, 6 Speed, 185k Miles, IMT 14′ Mechanics Body, 10,000-30 IMT Crane, Miller Welder

$112 ,000

1FVDCXBS3DHBU0283

105,126

Thanks for taking the time to check out this 2013 Freightliner M2 Service with, with a 14′ IMT Mechanics Body, IMT 10,000-30 series crane, and equipped with four wheel drive. Powered by a Cummins ISC rated at 270hp, mated to a six speed manual transmission. Showing 184,731 miles and 8,066 hours at the time of this writing.

All of the equipment functions as it should – this truck is turnkey ready to work, and has been fully serviced. Repairs completed prior to sale include:

Oil change and new fuel filters, new front and rear spring bushings, new batteries, new HVAC actuator, new oil cooler gasket, new crankcase filter, and a front end alignment.

The bed is a 14′ IMT service body – the exterior of the bed was just sandblasted and repainted, and shows like new. New bedliner applied to the work bench rear bumper. Interior compartment lighting throughout, as well as exterior LED work lights and boom lighting. All of the doors close, latch, and lock as they should. All lighting is operational.

The D1 and D2 compartment each have a new set of IMT drawers, eight drawers total. The D3 compartment is open with no shelving. One shelf over the driver wheel well, and three shelves in the driver rear compartment.

Work bench rear bumper with pass through bin storage and hydraulic outriggers. The crane compartment has one shelf, a Reelcraft hose reel, and the body control panel for the lighting and outriggers.

One shelf in the P3 compartment, two shelves in the P2 compartment as well as a small set of five Dualock drawers. The P1 compartment has three shelves, as well as torch bottle racks and straps.

The crane is an IMT 10,000-30 series, run off a factory wireless remote. The remote controls the compressor, and can turn the truck on and off. 10,000# maximum lifting capacity, with a two stage extension out to 30′ of reach.

The compressor is an IMT CAS40P hydraulic compressor, builds air quickly, showing 402 hours.

Mounted behind the compressor is a Miller Bobcat 250 welder, leads included, and showing 579 hours.

If you have any questions or need any additional photos, videos, or information – call or text anytime at 804-716-8487. Offered for sale by Truck World RVA in Oilville VA. All trucks are offered on a first come, first serve basis. Please call ahead to confirm availability.

Thanks for checking this one out!

Body Crane Body
Mileage 184,731
Fuel type Diesel
Engine 8.3 ISC Cummins
Year 2013
Transmission Manual
Drive 4WD
Exterior Color Solid White
Interior Color Grey
Vin 1FVDCXBS3DHBU0283