2018 Ford F550 Mechanics Truck, 4×4, Diesel, 11′ IMT Dominator Bed, Miller Trailblazer Welder, 7500-22 Series Crane

About this truck

Thanks for taking the time to check out this 2018 Ford F550 mechanics truck. Powered by a 6.7 powerstroke, automatic transmission, 4×4, showing 148,768 miles and 7,282 hours at the time of this writing. 1 owner fleet owned truck, coming to us out of Colorado and free of any rust. Equipped with an 11′ IMT Dominator service body, one set of drawers, one set of bolt drawers, hydraulic outriggers, a hydraulic CAS40P compressor, an IMT 7500-22 series crane, and a Miller Trailblazer welder. All of the equipment works as it should.

Fully serviced and ready to go to work. Repairs just completed include:

Oil change and new fuel filters, new upper oil pan and front and rear cover, new leaf spring bushings, new tires (all six), front and alignment, new crankcase breather, new front axle u joints, and some misc. lights replaced.

The entire exterior of the bed was sandblasted and repainted, and shows like new. New bedliner applied inside of the bed, and on the work bench rear bumper. Interior and exterior LED lighting, all operational. No rust inside of the bed or any compartments. All of the doors close, latch, lock, and seal as they should – all latches are keyed the same way. This Dominator bed is the style with torch-height compartments on both driver and passenger side – tons of storage in this bed.

The D1 compartment has a full set of eight drawers, with a shelf. Two shelves in the D2 compartment. One shelf over the driver wheel well compartment. A full set of eighteen bolt bins in the driver rear compartment.

Work bench rear bumper with pass through bin storage underneath, a tow hitch receiver, master slide locks for both bed sides, hydraulic outriggers, and rear facing LED bed lighting. The Miller welder is mounted inside of the bed, with the face in the P1 torch compartment.

The crane compartment houses a Reelcraft air hose reel, air regulator and drier, and body control panel to control the outriggers and the bed lighting. One shelf over the passenger wheel well compartment. The P2 compartment has two shelves. The P1 compartment has torch bottle racks, and one small shelf, with the welder face in the cabinet.

The crane is an IMT 7500-22 series, with a 7500# maximum lifting capacity and a two stage hydraulic extension out to 22′ of total reach. Run off a factory wireless remote, fully proportional. The remote controls the compressor, and can turn the truck on and off as well. 71 hours showing on the crane, 94 hours showing on the compressor.

If you have any questions or would like any more information, feel free to call or text anytime at 804-716-8487. Thanks for taking the time to check this one out.