2017 Peterbilt 337 Mechanics Truck, 14′ IMT Bed, Lube Skid, 10k Crane, 30′ Reach, Lincoln Welder, 192k Miles, 7400 Hours

About this truck

Thanks for taking the time to check out this 1 owner 2017 Peterbilt 337 Mechanics truck. Powered by a PX7 Paccar mated to an Allison Automatic, spring ride rear, 33k GVWR. Showing 191,819 miles and 7,367 hours at the time of this writing.

Equipped with a 14′ IMT Dominator bed, a 10,000-30 Series crane, a Lincoln Ranger welder, multiple sets of drawers, and a three section lube skid in the bed. All of the equipment has been tested and works as it should.

Fully serviced and turnkey ready to work. Repairs just performed include:

Oil change and new fuel filter, new belt and tensioner, new windshield washer pump, new front leaf springs, new slack adjuster, a new carrier assembly, and a front end alignment.

The bed is clean and has its factory paint intact. All of the doors close, latch, lock, and seal as they should. Overall dry and free of any major rust or damage, just some minor rock chipping etc. consistent with the age of the truck.

The D1 compartment has one shelf, and the control panel for the lube skid in the bed of the truck. The D2 compartment has a set of IMT drawers, eight total. Two shelves in the D3 compartment. Another set of IMT drawers over the driver wheel well, four drawers with a shelf. The driver rear compartment has one shelf.

Work bench rear bumper with vise, tow hitch receiver, hydraulic outriggers, and rear facing LED lighting. Pass through storage under the bumper. A lincoln ranger 225 welder is mounted on top of the driver’s side compartment and shows 4.7 hours. Runs as it should.

Mounted inside of the bed is a harbor freight gas compressor, three section product tank (2 fresh and one waste) and a grease barrel – all with fireball 300 air powered pumps.

The crane compartment houses the body control panel to control all bed lighting, and the outriggers. Air regulator and drier, reelcraft air hose reel, and a wireless factory remote. The remote controls the compressor as well.

The passenger wheel well compartment has a large set of bolt drawers, two shelves in the P3 compartment, one shelf in the P2 compartment. The P1 compartment has three shelves, as well as torch bottle racks.

The crane is an IMT 10,000-30 series, with a maximum lifting capacity of 10,000# and a two stage hydraulic extension out to 30′ of total reach.

All of the equipment functions as it should.

If you have any questions or need any additional photos, videos, or information – feel free to call or text anytime at 804-716-8487.

Offered for sale by Truck World RVA in Oilville VA. All trucks are offered on a first come, first serve basis – please call ahead to confirm availability.

Thanks for taking the time to check this one out!