2013 Kenworth T300 Mechanics Truck, 14′ Summit Service Body, 10629 Crane, Trailblazer Welder, PX9, 197k Miles

About this truck

Thanks for checking out this 1 owner 2013 Kenworth T300, coming to us out of Colorado. Powered by a Paccar PX8 mated to an Allison automatic, showing 197,125 miles and 9,031 hours. Air brakes, 33k GVWR, spring ride and locking rear.

Equipped with a 14′ Summit mechanics body, multiple sets of drawers, a Vanair RC40 hydraulic compressor, hydraulic outriggers, a Summit 10629 crane, waste oil tank, and a Miller Trailblazer 302 welder. All of the equipment works as it should.

Fully serviced, turnkey and ready to work. Repairs just completed include:

Oil change and new fuel filters, new rear trac bars and a front end alignment, new drive tires and new aluminum rims, new rear brake shoes, new AC compressor, and a new belt and tensioner.

The entire exterior of the body has been sandblasted and repainted, with new bedliner applied, and shows like new. All of the doors close, latch, lock, and seal as they should. There is little to no rust in the body, the truck lived its life in Colorado.

The D1 compartment has a set of seven Granite drawers, with a shelf over top. The D2 compartment has another set of seven Granite drawers and a shelf. Three american eagle drawers over the driver wheel well compartment. The driver rear compartment is open with no shelving.

Work bench rear bumper with pass through bin storage underneath, tow hitch receiver, and a working vise. Rear facing LEDs, a waste oil tank in the bed, and a Miller trailblazer 302 welder also mounted in the bed.

The crane compartment houses a Hannay air hose reel, air regulator and drier, body control panel that controls the outriggers and bed lighting, and a new OEM wireless remote.

Over the passenger wheel well is a full set of bolt bins, and a shelf over top. The P2 compartment has the diaphragm waste oil pump, suction reel (no suction hose), and two shelves. The P1 compartment steps down, so it is tall enough to fit torch bottles, and has two shelves.

The crane is a Summit 10629, with a 10,000# maximum lifting capacity and a two stage extension out to 29′ of total reach. The compressor is a Vanair RC40 hydraulic compressor, and shows 1,071 hours.

If you have any questions or if you need any additional photos, videos, or information – feel free to call or text anytime at 804-716-8487.

All trucks are offered on a first come, first serve basis. Please call ahead to confirm availability.